3Com S7906E Configuration Manual page 322

User 1 has full access to Channel 1 and 60-second preview access to Channel 2.
User 2 has access to Channel 2 only.
Network diagram
Figure 3-4 Network diagram for multicast configuration (in multicast control mode)
Eth2/0/1
OLT
OLT3/0/1
POS
ONU
UNI2
UNI1
User1
Configuration procedure
# Map the multicast addresses to multicast VLANs.
<Sysname> system-view
[Sysname] ftth
[Sysname-ftth] multicast vlan-id 1002 dest-ip 225.1.1.1
[Sysname-ftth] multicast vlan-id 1003 dest-ip 225.1.2.1
[Sysname-ftth] quit
# Enable IGMP snooping globally.
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
# Enable IGMP snooping in VLAN 1002 and VLAN 1003.
[Sysname] vlan 1002
[Sysname-vlan1002] igmp-snooping enable
[Sysname-vlan1002] vlan 1003
[Sysname-vlan1003] igmp-snooping enable
[Sysname-vlan1003] quit
# Configure the multicast mode of the ONU as the multicast control mode.
[Sysname-Onu3/0/1:1] multicast-mode multicast-control
# Configure UNI 1 to allow the user attached to it to access Channel 1 and to preview Channel 2 for only
60 seconds, and configure the port to remove the multicast VLAN tags from downlink multicast packets.
[Sysname-Onu3/0/1:1] uni 1 multicast-control multicast-address 225.1.1.1 rule permit
[Sysname-Onu3/0/1:1] uni 1 multicast-control multicast-address 225.1.2.1 rule preview
time-slice 1
[Sysname-Onu3/0/1:1] uni 1 multicast-strip-tag enable
Multicast Source
User2
3-22