Configuring Is-Is Routing Information Control; Configuring Is-Is Link Cost - 3Com S7906E Configuration Manual

You can only perform this configuration for a broadcast network with only two attached routers.

Configuring IS-IS Routing Information Control

Configuration Prerequisites
Before the configuration, accomplish the following tasks:
Configure network layer addresses for interfaces, and make sure adjacent nodes are reachable to
each other at the network layer.
Enable IS-IS.

Configuring IS-IS Link Cost

The IS-IS cost of an interface is determined in the following order:
ISIS cost specified in interface view.
ISIS cost specified in system view. The cost is applied to the interfaces associated to the IS-IS
process.
Automatically calculated cost: When the cost style is wide or wide-compatible, IS-IS
automatically calculates the cost using the formula: interface cost= (bandwidth reference
value/interface bandwidth) ×10. When the cost style is of another type: if the interface bandwidth
does not exceed 10 Mbps, the interface cost equals 60; if the interface bandwidth does not exceed
100 Mbps, the interface cost equals 50; if the interface bandwidth does not exceed 155 Mbps, the
interface cost equals 40; if the interface bandwidth does not exceed 622 Mbps, the interface cost
equals 30; if the interface bandwidth does not exceed 2500 Mbps, the interface cost equals 20; if
the interface bandwidth exceeds 2500 Mbps, the interface cost equals 10.
If none of the above costs is used, a default cost of 10 applies.
Configuring an IS-IS cost for an interface
Follow these steps to configure a cost for an interface:
To do...
Enter system view
Enter IS-IS view
Specify an IS-IS cost style
Return to system view
Enter interface view
Use the command...
system-view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
cost-style { narrow | wide |
wide-compatible | { compatible |
narrow-compatible } [ relax-spf-limit ] }
quit
interface interface-type
interface-number
1-19
Remarks
––
––
Optional
narrow by default
––
––