3Com S7906E Configuration Manual page 686

Switch C is configured as an ASBR to redistribute external routes (static routes). Routing
information is propagated properly in the AS.
Figure 1-22 Network diagram for OSPF redistributing routes from outside of an AS
Configuration procedure
1) Configure IP addresses for interfaces (omitted).
2) Configure OSPF basic functions (Refer to
3) Configure OSPF to redistribute routes.
# On Switch C, configure a static route destined for network 3.1.2.0/24.
<SwitchC> system-view
[SwitchC] ip route-static 3.1.2.1 24 10.4.1.2
# On Switch C, configure OSPF to redistribute static routes.
[SwitchC] ospf 1
[SwitchC-ospf-1] import-route static
4) Verify the configuration.
# Display the ABR/ASBR information of Switch D.
<SwitchD> display ospf abr-asbr
OSPF Process 1 with Router ID 10.5.1.1
Routing Table to ABR and ASBR
Type Destination
Intra 10.3.1.1
Inter 10.4.1.1
# Display the OSPF routing table of Switch D.
<SwitchD> display ospf routing
OSPF Process 1 with Router ID 10.5.1.1
Routing for Network
Destination
10.2.1.0/24
Area
0.0.0.2
0.0.0.2
Routing Tables
Cost Type NextHop
22 Inter 10.3.1.1
Configuring OSPF Basic
Cost Nexthop
10 10.3.1.1
22 10.3.1.1
AdvRouter
10.3.1.1
1-53
Functions).
RtType
ABR
ASBR
Area
0.0.0.2