Out Of Memory - Xerox Phaser 6130 Service Manual

Error Messages and Codes

Out of Memory

Applicable Chain Link
Initial Actions
3-22
Troubleshooting Procedure (continued)
Step Actions and Questions
4 Reseat plugs and jacks on the Image
Processor Board (refer to the
procedure on page 8-60).
Does the error still occur when the
power is turned OFF and ON?
5 Re-download the correct file for
6130N from the Xerox web site.
Does the error still occur when the
power is turned OFF and ON?
The printer memory is full and cannot continue to print. Print job requires
additional memory.
Chain Link 016-718: Out of memory
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL8.1.9
Memory Card (Option)
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the required memory for the
1
print job.
2. Print a small size file (like a
Windows test print).
3. Does the error still occur?
2 Reseat the memory card. Does the
error still occur?
Yes
Go to step 4.
Replace the
Image
Processor Board
(page 8-60).
Wiring and Plug/Jack Map References
"Map 3 - LVPS, Drive Motors, I/P Board, AC
Power" on page 10-10
"Controller" on page 10-31
Yes
Go to step 2.
Go to step 3.
Phaser 6130 Color Laser Printer Service Manual
No
Complete
Complete
No
Add memory
card or separate
the print job.
Complete.