Table of Contents
Advertisement
13.5.3.2
Changing the set speed of the motor manually
Overview
You manually change the motor setpoint speed in menu "Operation and monitoring" via the
following menu entries:
• "Continuous operation":
• "Jog mode"
Procedure
Figure 13-6
To change the set speed of the motor manually, proceed as follows:
1. Press the "MANUAL/AUTO" key.
2. Continue as under item 3
OR
1. In the navigation bar, navigate to the "Operation and monitoring" menu.
Confirm the selection using the "OK" key.
2. Select the "Continuous operation" or "Jog mode" menu item.
Confirm the selection using the "OK" key.
3. You have two options for changing the value of the set speed:
– You change the value of the set speed of the motor in the bar chart using the arrow keys.
– You enter the precise numerical value for the set speed.
4. Press the "ON" key to start the motor.
– Continuous operation:
– Jog mode:
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
Changing the set speed of the motor
To do so, press the "OK" key.
A dialog box to enter the value is displayed, and you change the value of the set speed.
Use the arrow keys to increase or decrease the motor speed in continuous operation.
Press the "ON" key to enter a value.
The motor is rotated manually by the specified value every time the "ON" key is pressed.
The motor rotates until the "ON" key is released again.
Operation and monitoring with SINAMICS SDI Standard
13.5 Functions
311
Advertisement
Table of Contents
