Table of Contents
Advertisement
• p0215 = 2 Siemens braking resistor
All of the settings required to thermally monitor the braking resistor are saved in the
converter.
• p0215 = 3 Third-party braking resistor
Additional settings are required to thermally monitor the braking resistor.
Parameter p0219[0] defines the maximum braking power that the braking resistor is
expected to absorb.
Figure 14-192
Example
The following are typical applications for dynamic braking:
• Centrifuges
• Horizontal conveyors
• Vertical and inclined conveyors
• Hoisting gear
You can find an example for configuring and commissioning a drive with braking resistor
on the Internet: Dimensioning and commissioning of serial hoisting equipment
support.industry.siemens.com/cs/ww/en/view/103156155).
Parameters
The following list contains the parameters of the "Dynamic braking" function.
14.11.11
Motor holding brake
Overview
A motor holding brake holds a switched-off motor in place.
When controlled as follows, the "Motor holding brake" function minimizes the wear of an
electromechanical brake:
• The brake opens once the motor is magnetized.
• The converter switches off the motor when the motor holding brake is closed.
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
Example of maximum braking power in an application
Functions
14.11 Drive functions
(https://
605
Advertisement
Table of Contents
