Table of Contents
Advertisement
Connecting
7.1 Line system, motor and braking resistor
Procedure
Proceed as follows to remove the housing cover:
Figure 7-4
1. Using a torx screwdriver, release the fixing screws of the housing cover.
The screws are connected to the housing cover and are captive.
2. Swivel the housing cover towards the front and then lift the housing cover upward.
Proceed as follows to install the housing cover:
Figure 7-5
1. Place the housing cover with the recess at the converter housing and swivel the housing
cover downward.
2. Using a torx screwdriver, tighten the fixing screws of the housing cover. Tightening torque:
2 Nm (26.6 lbf in).
158
Removing the IP55 housing cover
Attaching the IP55 housing cover
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
SINAMICS G220 converter
Advertisement
Table of Contents
