Series Commissioning - Siemens SINAMICS G220 Operating Instructions Manual

Series commissioning

12.1 Series commissioning
Overview
For series commissioning, transfer the data and settings of converter 1 to converter 2 or other
converters.
Requirement
Converter 2 must comply with the following requirements:
• The rated power of converter 2 corresponds to the rated power of converter 1.
• The firmware version of converter 2 is higher than or equal to the firmware version of
converter 1.
• The machines that are commissioned via series commissioning are identical in terms of the
application, converter and motor.
• Converter 2 has the factory setting.
Description of function
There are two options when carrying out series commissioning of the converter:
• Series commissioning with memory card
All settings on the memory card are transferred to converter 2.
• Series commissioning using the web server
All settings from the drive data backup are transferred to converter 2.
Information about the operating units and web browsers supported by the web server is
provided in Chapter "Fundamentals (Page 211)".
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
12
297