Table of Contents
Advertisement
Installation
5.7 Option modules
Procedure
Figure 5-16
Proceed as follows to mount option module OM-SMT in the option slot of the IP20 converter:
1. Remove the front cover (frame size FSA) or open the front door of the converter.
2. Insert option module OM-SMT into the option slot of the converter.
3. Push option module OM-SMT up until it snaps in flush.
4. Tighten the fixing screw with a T20 torx screwdriver, applying a torque of 2 Nm.
5. Press the cover caps onto the fixing screws.
6. Place the front cover (frame size FSA) on the converter or close the front door of the
converter.
Result
Option module OM-SMT is connected to the converter.
5.7.5
Mounting option module OM-SMT, converter in degree of protection IP55
Overview
Option Module OM-SMT is mounted in the option slot of the converter.
114
Mounting option module OM-SMT in the option slot of the IP20 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
SINAMICS G220 converter
Advertisement
Table of Contents
