Siemens SINAMICS G220 Operating Instructions Manual page 378

Functions
14.4 PROFINET communication
9000 hex Hardware/software error
9001 hex Network fault
9002 hex Supply voltage fault
9003 hex DC link overvoltage
9004 hex Power electronics faulted
9005 hex Overtemperature of the electronic components
9006 hex Ground fault / inter-phase short circuit
9007 hex Motor overload
9008 hex Communication error to the higher-level control
system
9009 hex Safety monitoring channel has identified an error 9013 hex
Figure 14-27 Structure of the channel diagnostics
To read out the diagnostics data, the control requests the diagnostics data from the converter
via "Read data set", e.g. using a read record with index 800C hex.
The following rules apply:
• 1 message block (=ChannelDiagnosisData)
if (one or several) faults of the same message class are detected at the converter
• n message blocks
if at the converter, n faults of different message classes are detected
376
900A hex Position/speed actual value incorrect or not avail‐
able
900B hex Internal (DRIVE-CLiQ) communication error
900C hex Infeed faulted
900D hex Braking module faulted
900E hex Line filter faulted
900F hex External measured value / signal state outside the
permissible range
9010 hex Application / technological function faulted
9011 hex Error in the parameterization / configuration /
commissioning procedure
9012 hex General drive fault
Auxiliary unit faulted
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
SINAMICS G220 converter