Identification & Maintenance (I&M) Data - Siemens SINAMICS G220 Operating Instructions Manual

15.2 Identification & Maintenance (I&M) data
Technical data
The converter supports the following identification and maintenance (I&M) data.
Table 15-3 I&M data
I&M data Format
I&M0 unsigned8[54] PROFINET
I&M1 Visible String [32]
Visible String [22]
I&M2 Visible String [16]
I&M3 Visible String [54]
I&M4 Octet String[54]
When requested, the converter transfers its I&M data to a higher-level control or to a PC/PG
with installed STEP 7 or TIA Portal.
Table 15-4 I&M0
Designation
MANUFACTURER_ID
ORDER_ID
SERIAL_NUMBER
HARDWARE_REVISION
SOFTWARE_REVISION
REVISION_COUNTER
PROFILE_ID
PROFILE_SPECIFIC_TYPE
IM_VERSION
IM_SUPPORTED
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
Explanation
Converter-specific data, read only
Plant/system identifier
Location code
Date
Any comment or remark
Check signature to track changes for Safety Inte‐
grated.
This value can be changed by the user.
Format
unsigned16
Visible String [20]
Visible String [16]
unsigned16
char, unsigned8[3]
unsigned16
unsigned16
unsigned16
unsigned8[2]
unsigned16
15.2 Identification & Maintenance (I&M) data
Example for the content
See below
"ak12-ne.bo2=fu1"
"sc2+or45"
"2013-01-21 16:15"
-
Values of r9780[0],
r9781[0] and r9782[0]
Example for the content
2A hex (=Siemens)
"6SL4113-0CA12-2AF0"
"T-R32015957"
0001 hex
"V" 06.10.00
0000 hex
3A00 hex
0000 hex
01.01
001E hex
System messages
741