Table of Contents
Advertisement
Requirement
NOTICE
Damage to the option module by withdrawing and inserting under voltage (hot
swapping)
Withdrawing and inserting the option module when the power supply is switched on can
damage the option module or cause the option module to malfunction.
• Switch off the converter power supply before you withdraw or insert the option module.
You will need a torx T20 screwdriver.
Procedure
Proceed as follows to mount Option Module OM-IIoT in the option slot of the IP55 converter:
1. Remove the screws of the housing cover with a T20 torx screwdriver.
Figure 5-21
2. Swivel the housing cover slightly upward and then lift the housing cover off in an upward
direction.
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
Removing the housing cover
Installation
5.7 Option modules
119
Advertisement
Table of Contents
