Table of Contents
Advertisement
16. Clear all bystanders from the area.
17. Start the engine.
18. Extend center-link (A) fully. Ensure that there is some slack
in harness (B).
19. Retract center-link (A) fully. Ensure that there is not an
excessive amount of harness (B) hanging down.
20. Shut down the engine, and remove the key from the
ignition.
21. Adjust harness (B) as needed.
22. Tighten all the cables along the harness.
23. If this is the first time the header is connected to the
windrower, calibrate the header. For instructions, refer to
5.6 Calibrating Header on HarvestTouch
Rotary Disc-Only Configuration – Hard-Plumbed Connections
The rotary disc-only configuration allows the windrower to operate with compatible rotary disc headers. The hydraulic
connections must be torqued correctly when using hard-plumbed fittings.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and
movable) hydraulic couplers.
1. Shut down the engine, and remove the key from the ignition.
2. Approach platform (A) on the left side of the windrower.
Ensure that the cab door is closed.
3. Push latch (B) and pull platform (A) toward the walking
beam until it stops and the latch engages.
262175
ATTACHING HEADERS TO WINDROWER
™
Display, page
227.
180
A
Figure 5.183: Electrical Connection
A
Figure 5.184: Left Platform
B
B
1015479
Revision A
Advertisement
Table of Contents
