Table of Contents
Advertisement
27. Disconnect hose management system (A) from the
windrower by pulling latch lever (B) to open the latch. Keep
the latch open and move hose management system (A)
away from the header with handle (C).
28. Pivot hose management system (B) forward with
handle (A), and engage hook (D) into latch (C) on the
header.
29. Back the windrower away from the header.
30. Shut down the engine, and remove the key from
the ignition.
31. Reinstall clevis pin (B) into header support (C) and secure it
with hairpin (A). Repeat this step at the opposite side of the
windrower.
262175
ATTACHING HEADERS TO WINDROWER
138
C
Figure 5.91: Hydraulic Hose Management System
B
C
Figure 5.92: Hydraulic Hose Management System
C
Figure 5.93: Header Stand
A
B
A
D
A
B
Revision A
Advertisement
Table of Contents
