Table of Contents
Advertisement
4. Lift header support (A), and place four 35 x 89 mm
(2 x 4 in.) blocks (B) under both of the header supports.
Ensure that the boot's bottom edge (C) is parallel with
the ground.
NOTE:
Do NOT stack blocks (B) crosswise; doing so can make the
header unstable when you are attempting to connect the
header and the windrower. Stack blocks (B) so that they are
aligned with each other.
5. Start the engine.
262175
ATTACHING HEADERS TO WINDROWER
162
A
B
Figure 5.146: Header Support
C
Revision A
Advertisement
Table of Contents
