Checking Engine Gearbox Lubricant Level And Adding Lubricant - M2170 Windrowers - MacDon M2170 Unloading And Assembly Instructions

Adding engine coolant
3. Add coolant to the recovery tank as follows:
a. Remove pressurized cap (A) from the coolant
recovery tank.
b. Add coolant to the recovery tank at a rate not
exceeding 11 L/min (3 gpm) until the recovery tank is
half-full and the coolant level is at MAX COLD line (B)
c. Replace cap (A).
4.1.7 Checking Engine Gearbox Lubricant Level and Adding Lubricant – M2170
Windrowers
Ensure that the gearbox lubricant level is correct in order to maximize the service life of its components.
1. Open the hood. For instructions, refer to the windrower operator's manual.
2. Locate gearbox oil level check plug (A) under the
windrower.
3. Remove oil level check plug (A). The lubricant should be
visible through the hole. Some lubricant may leak from the
level check port.
262175
PERFORMING PREDELIVERY CHECKS
Figure 4.13: Coolant Recovery Tank Cap and MAX
COLD Fill Line
Figure 4.14: Gearbox Lubricant Check Plug
55
A
B
A
Revision A