Table of Contents
Advertisement
4. Retrieve hydraulic hoses (A) from the header and route the
hose bundle under the windrower frame.
NOTE:
Adding anti-seize compound to the hose holder pin will
make future removal easier.
5. Insert pin (B) into hole (C) in the windrower frame.
IMPORTANT:
Route the hydraulic hoses as straight as possible, avoiding
wear points that could damage the hoses. To prevent
abrasion damage, the hoses should have enough slack to
pass by the multicoupler bracket without contacting it. To
adjust the slack in the hoses, loosen the clamps below
pin (B), adjust the hoses, then retighten the hose holder.
6. If using hard-plumbed fittings (A), proceed to Step
171. If using quick couplers (B), proceed to Step
171.
262175
ATTACHING HEADERS TO WINDROWER
7, page
8, page
170
Figure 5.160: Hose Support Attachment
Figure 5.161: Hard-Plumbed Fittings Compared to
Quick Couplers
B
C
A
A A
A B
Revision A
Advertisement
Table of Contents
