Table of Contents
Advertisement
7. Prepare the center-link as follows:
• If not equipped with the Center-Link Alignment kit:
Relocate pin (A) in the frame linkage as needed to raise
center-link (B) until the hook is above the attachment
pin on the header.
• If equipped with the Center-Link Alignment kit: Press
REEL UP switch (D) on the ground speed lever (GSL) to
raise the center-link until the hook is above the
attachment pin on the header.
IMPORTANT:
Ensure that the center-link is positioned high enough that it
does not contact the header as the windrower approaches
the header.
8. Press HEADER DOWN switch (C) on the GSL until the
windrower lift linkages are fully lowered.
9. Drive the windrower slowly forward until feet (A) enter
supports (B). Continue to drive slowly forward until the feet
engage the supports and the header nudges forward.
10. Ensure that feet (A) are properly engaged in supports (B).
262175
ATTACHING HEADERS TO WINDROWER
164
A
C
Figure 5.148: Center-Link without Self-Alignment
A
Figure 5.149: Header Support
B
D
B
Revision A
Advertisement
Table of Contents
