Calibrating Header On Harvesttouch Display; Display - M2 Series Windrowers - MacDon M2170 Unloading And Assembly Instructions

5.6 Calibrating Header on HarvestTouch
™
The HarvestTouch Display recognizes when a header is attached to the windrower and determines which systems will
require calibration.
The following sensors may require calibration, depending on the type of header attached to the windrower:
• Header height
• Header angle
• Header float left
• Header float right
Recalibration is required in the following circumstances:
• The HarvestTouch
™
Display is replaced
• A position sensor is replaced
• Sensor readouts are erratic
• A pump has been replaced
• A new header type or attachment is connected to the windrower
Refer to following topics for information on calibrating header systems:
•
5.6.1 Calibrating Knife Drive on HarvestTouch
•
5.6.2 Calibrating Header Position Sensors on HarvestTouch
5.6.1 Calibrating Knife Drive on HarvestTouch
When a header is attached to the windrower, the windrower's HarvestTouch
choose the appropriate settings for that header. Before it can be operated, however, the header's knife drive must be
calibrated to ensure that the knife drive pump output is accurate.
DANGER
Ensure that all bystanders have cleared the area.
NOTE:
This calibration MUST be performed with the engine running and the header engaged.
1. Clear all bystanders from the area.
2. Start the engine.
262175
ATTACHING HEADERS TO WINDROWER
™
• Reel height
• Reel fore-aft
• Swath compressor
• Knife drive
Display – M2 Series Windrowers, page 227
™
™
Display, page 231
™
227
Display
Display – M2 Series Windrowers
™
Display will recognize the header ID and
Revision A