Table of Contents
Advertisement
15. Secure the barrel end of anti-shimmy dampener (A)
(MD #202898) to the forward hole in support (B) with one
M16 x 75 bolt (C) (MD #181511) and one M16 nut (D)
(MD #152520). Install the bolt from under the support. Do
NOT fully tighten the hardware yet.
16. Secure the barrel end of second anti-shimmy dampener (A)
(MD #202898) to support (B) at the aft hole location with
one M16 x 90 bolt (MD #252533) and M16 nut (C)
(MD #152520). Install the bolt from under the support. Do
NOT fully tighten the hardware yet.
17. Rotate the caster so that arm (D) is aligned with the
walking beam.
18. Attach the rod ends of the anti-shimmy dampeners to the
arm with M16 x 90 bolt (A) (MD #252533) and three
hardened washers (B) (MD #120901).
NOTE:
Washers (B) are stamped with "L9".
19. Torque bolt (A) to 244 Nm (180 lbf·ft).
20. Install jam nut (C) (MD #136473). Torque the nut to 138 Nm
(102 lbf·ft).
21. Tighten bolts (D) at the barrel end of the anti-shimmy
dampeners. Torque the nuts on bolts (D) to 138 Nm
(102 lbf·ft).
IMPORTANT:
Ensure that the arm remains parallel to the walking beam
while the hardware is tightened. Do NOT overtighten the
hardware.
22. Repeat Step
14, page 36
anti-shimmy system on the opposite side of the windrower.
262175
ASSEMBLING WINDROWER
to Step
21, page 37
to install the
A
Figure 3.36: Anti-Shimmy System – Left Side
D
Figure 3.37: Anti-Shimmy System – Left Side
A
Figure 3.38: Anti-Shimmy System – Left Side
37
B
D
C
C
A
B
B
C
D
Revision A
Advertisement
Table of Contents
