Table of Contents
Advertisement
15. Clear all bystanders from the area.
16. Start the engine.
17. Extend center-link (A) fully. Ensure that there is some slack
in harness (B).
18. Retract center-link (A) fully. Ensure that there is not an
excessive amount of harness (B) hanging down.
19. Shut down the engine, and remove the key from the
ignition.
20. Adjust harness (B) as needed.
21. Tighten all the cables along the harness.
22. If this is the first time the header is connected to the
windrower, calibrate the header. For instructions, refer to
5.6 Calibrating Header on HarvestTouch
5.4.4 Connecting R2 Series Rotary Disc Header Hydraulic and Electrical Systems –
M2260 Windrower
The header's hydraulic and electrical multicoupler will need to be connected to the windrower.
Proceed to the relevant procedure:
For auger/rotary disc/draper-ready configuration (A), refer to
Auger/Rotary Disc/Draper-Ready Configuration – Quick Coupler
Connections, page 175
for instructions.
262175
ATTACHING HEADERS TO WINDROWER
™
Display, page
227.
174
A
Figure 5.169: Electrical Connection
A A
Figure 5.170: Header Hydraulics Configurations –
Auger/Rotary Disc/Draper-Ready
B
1036608
Revision A
Advertisement
Table of Contents
