Table of Contents
Advertisement
5. Ensure that hose (A) is disconnected from windrower
receptacle (B) and placed in storage cup (C) on the
multicoupler.
6. Remove the extra hydraulic quick couplers from pressure
hose (A) and return hose (B). These can be stored and used
as replacement parts.
NOTE:
It is normal to have an extra set of quick couplers on
windrowers with the auger/rotary disc/draper-ready
configuration.
7. Connect the hydraulic hoses to the windrower with the
quick coupler fittings as follows:
a.
Connect the pressure hose female coupler to
receptacle (A).
b. Connect the return hose male coupler to
receptacle (B).
c.
Connect case drain hose (C) to the mating 1/2 in.
coupler on the frame.
NOTE:
This coupler is only present if the Low Pressure Case
Drain kit (B6698) has been installed.
IMPORTANT:
Do NOT connect the case drain coupler to 1/2 in. flat
faced coupler (E).
d. Connect the electrical harness to receptacle (D).
262175
ATTACHING HEADERS TO WINDROWER
212
A
C
Figure 5.252: Couplers – Auger/Rotary/Draper
Header-Ready Configuration with Case Drain Kit
Installed
B
Figure 5.253: Hydraulic Quick Couplers
D
Figure 5.254: Hydraulics and Electrical Installed –
Auger/Rotary/Draper-Ready Windrower
B
A
C
E
A
B
Revision A
Advertisement
Table of Contents
