Table of Contents
Advertisement
14. Clear all bystanders from the area.
15. Start the engine.
16. Extend center-link (A) fully. Ensure that there is some slack
in harness (B).
17. Retract center-link (A) fully. Ensure that there is not an
excessive amount of harness (B) hanging down.
18. Shut down the engine, and remove the key from the
ignition.
19. Adjust harness (B) as needed.
20. Tighten all the cables along the harness.
21. If this is the first time the header is connected to the
windrower, calibrate the header. For instructions, refer to
5.6 Calibrating Header on HarvestTouch
Rotary Disc-Only Configuration – Quick Coupler Connections
The rotary disc-only configuration allows the windrower to operate with compatible rotary disc headers. Attaching the
header's hydraulic connections to the windrower's ports using quick couplers does not require any additional tools or
hardware.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and
movable) hydraulic couplers.
1. Shut down the engine, and remove the key from the ignition.
262175
ATTACHING HEADERS TO WINDROWER
™
Display, page
227.
184
A
Figure 5.192: Electrical Connection
B
Revision A
Advertisement
Table of Contents
