Table of Contents
Advertisement
11. Tighten the hardware as follows:
a.
Snug bottom bolts (A), then snug rear bolts (B).
b. Torque rear bolts (B) to 757 Nm (560 lbf·ft).
c.
Torque bottom bolts (A) to 757 Nm (560 lbf·ft).
IMPORTANT:
Torque the bolts again after the first five hours of operation,
and then once more after ten hours of operation.
12. Repeat Step
5, page 35
the other caster. Ensure that the casters are spaced equally
from the center of the windrower as shown.
13. Lower the windrower to the ground.
14. If the windrower already has casters installed:
a.
Remove and retain retaining ring (A).
b. Remove and discard yellow spacer (B). Leave
washer (C) in place.
c.
Place anti-shimmy arm (left assembly shown) (D) onto
the spindle and washer (E).
NOTE:
Ensure that the arm is positioned so that there is no
clearance at the top and bottom of the walking beam
extension.
d. Rotate the spindle until notch (F) aligns with the notch
in the anti-shimmy arm.
e.
Install key (G) (MD #135296) into the notch.
f.
Secure the arm using retaining ring (H) as shown.
g.
Tighten nut (J), and torque it to 195 Nm (144 lbf·ft).
262175
ASSEMBLING WINDROWER
to Step
11, page 36
to reposition
Figure 3.33: Walking Beam Bolts
=
Figure 3.34: Walking Beam Adjustment
A
C
Figure 3.35: Anti-Shimmy Arm – Left Side
36
B
A
=
F
J
B
D
E
H
G
Revision A
Advertisement
Table of Contents
