Table of Contents
Advertisement
7. For grass seed headers (GSS), connect the additional four
hoses supplied with the grass seed version of the header as
follows:
a.
Remove the plug (not shown) from drive manifold port
R1. Install 45° fitting (A) in port R1. Connect hose (C)
(blue cable tie) to fitting (A).
NOTE:
The other end of hose (C) connects to the grass seed
module's drum on the right side of the header.
b. Remove the plug (not shown) from drive manifold port
CP2. Install 45° fitting (B) in port CP2. Connect hose (D)
(red cable tie) to fitting (B).
NOTE:
The other end of hose (D) connects to the grass seed
module's drum on the left side of the header.
c.
Connect hose (green cable tie) with female quick
coupler (E) to coupler (F) as shown.
d. Connect hose (yellow cable tie) with male quick
coupler (G) to coupler (H) as shown.
8. Free electrical harness (A) from adjustable strap (B).
262175
ATTACHING HEADERS TO WINDROWER
182
G
E
D
Figure 5.187: Grass Seed Hydraulic Connections –
Rotary Disc Configuration
Figure 5.188: Electrical Harness Secured to Center-Link
H
F
B
A
C
B
A
Revision A
Advertisement
Table of Contents
