Detaching R2 Series Rotary Disc Header - MacDon M2170 Unloading And Assembly Instructions

14. Pull platform (A) toward the cab until it stops and the latch
is engaged.
DANGER
Ensure that all bystanders have cleared the area.
15. Clear all bystanders from the area.
16. Start the engine.
17. Extend center-link (A) fully. Ensure that there is some slack
in harness (B).
18. Retract center-link (A) fully. Ensure that there is not an
excessive amount of harness (B) hanging down.
19. Shut down the engine, and remove the key from the
ignition.
20. Adjust harness (B) as needed.
21. Tighten all the cables along the harness.
22. If this is the first time the header is connected to the
windrower, calibrate the header. For instructions, refer to
5.6 Calibrating Header on HarvestTouch

5.4.5 Detaching R2 Series Rotary Disc Header

The instructions in this section will show you how to properly detach the header when replacing the header with a
different one or when storing the header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
262175
ATTACHING HEADERS TO WINDROWER
™
Display, page 227.
188
Figure 5.201: Left Platform
A
Figure 5.202: Electrical Connection
A
B
Revision A