Table of Contents
Advertisement
10. The display changes to show that the calibration procedure
has started. The knife drive calibration should automatically
proceed through all nine stages.
NOTE:
If the engine speed is less than 1500 rpm prior to starting
the calibration procedure, the system will raise the engine
speed to 1500 rpm.
NOTE:
During the calibration procedure, the speed of the header
and of the engine will vary.
NOTE:
Select X icon (A) on the screen or use the HEADER
DISENGAGE switch at any time during the calibration
process to exit the procedure without saving your progress.
The engine will resume the speed at which it was operating
before the calibration process began.
NOTE:
If error message (A) appears during the calibration process,
follow the instructions in the message to fix the error. Select
X icon (B) to exit the message. If the knife calibration
procedure fails:
• Confirm that the engine and hydraulics are at operating
temperature.
• Confirm that the hydraulic system is free of any
restrictions and is in working order.
• Confirm that the throttle is working:
– Check the engine codes to confirm that the engine is
not derated or throttle-inhibited.
– The throttle is controlled via the powertrain's CAN
network 1. Check the network's wiring and
connectors for an open or intermittent connection.
• Confirm that the sensor mounting is secured properly and that the sensor's gap is set correctly.
• Check the sensor wiring and connectors for an intermittent connection.
• Replace the sensor.
262175
ATTACHING HEADERS TO WINDROWER
230
Figure 5.295: Calibration Page
Figure 5.296: Calibration Page
A
A
B
1033530
Revision A
Advertisement
Table of Contents
