Table of Contents
Advertisement
8. Push latch (A) to unlock platform (B).
9. Pull platform (A) toward the cab until it stops and the latch
is engaged.
10. Calibrate the header on the windrower. For instructions,
refer to
5.6 Calibrating Header on HarvestTouch
page
227.
5.5.3 Connecting R113 Rotary Disc Header Hydraulic and Electrical Systems – M2260
Windrower
The header's electrical and hydraulic systems must be connected to the windrower. The procedure for connecting the
header's hydraulic and electrical systems to the windrower differs depending on the configuration of the windrower.
IMPORTANT:
The Low Pressure Case Drain kit (B6698) must be installed on the M2260 windrower before an R113 Rotary Disc Header
can be connected to it.
The procedure for connecting the header's hydraulic connections to the windrower depends on the windrower's
configuration:
• Auger/rotary disc/draper header-ready windrowers are equipped with a set of hydraulic quick couplers which are
compatible with the header drive hoses on the rotary disc header.
• Rotary disc header-ready windrowers are equipped with hard-plumbed hydraulic connections.
NOTE:
The hydraulic bundle includes a complete set of quick couplers that can be installed onto a windrower configured for use
with rotary disc headers.
262175
ATTACHING HEADERS TO WINDROWER
™
Display,
209
B
Figure 5.245: Left Platform
Figure 5.246: Left Platform
A
1015478
A
Revision A
Advertisement
Table of Contents
