Table of Contents
Advertisement
NOTE:
If the voltage of any sensor falls below its acceptable range
during calibration, a message appears after completing the
calibration with a list of sensors reporting out-of-range
voltages. Adjust the sensors as needed and repeat the
calibration process from the beginning.
11. When the second stage of the calibration is complete, the
calibration is complete. Select RESUME icon (A) on the
screen to configure the HEADER FLOAT setting, or select the
HOME or BACK icons to exit.
NOTE:
The engine speed returns to the speed prior to calibration
when the second stage of the calibration is complete.
262175
ATTACHING HEADERS TO WINDROWER
234
Figure 5.305: Sample of Failed Calibration Display
Message
Figure 5.306: Calibration Page
A
Revision A
Advertisement
Table of Contents
