11. Lower the header fully using HEADER DOWN switch (A).
12. Press HEADER TILT switches (B), as needed, on the GSL to
release the load on center-link.
13. Windrowers with self-aligning center-link:
a.
Press REEL UP switch (A) to disengage the center-link
from the header.
b. Shut down the engine, and remove the key from the
ignition.
14. Windrowers without self-aligning center-link:
a.
Shut down the engine, and remove the key from the
ignition.
b. Disconnect the center-link by lifting release (A) and lift
hook (B) off the header.
262175
ATTACHING HEADERS TO WINDROWER
222
B
A
Figure 5.277: GSL
Figure 5.278: GSL
Figure 5.279: Hydraulic Center-Link
A
A
B
Revision A