Table of Contents
Advertisement
10. Attach sling (A) on caster assembly (B) to a suitable lifting
device.
11. Tilt walking beam (C) and maneuver caster assembly (B) so
that spindle (D) can be installed onto walking beam (C).
12. Install washer (A) onto the spindle.
NOTE:
Washer (A) was retained during Step
13. Place anti-shimmy arm (B) (left assembly shown) onto the
spindle and washer (A).
NOTE:
Ensure that the arm is positioned so that there is no
clearance at the top and bottom of the walking beam
extension.
14. Rotate the spindle until notch (C) aligns with the notch in
the anti-shimmy arm (left arm shown).
15. Install key (D) (MD #135296) into the notch.
16. Install retaining ring (E).
17. Tighten nut (F). Torque the nut to 195 Nm (144 lbf·ft).
18. Remove the sling from the caster assembly.
19. Repeat Step
7, page 24
second caster assembly.
262175
ASSEMBLING WINDROWER
2, page
23.
to Step
18, page 25
install the
C
D
B
Figure 3.12: Caster Assembly Ready for Installation
Figure 3.13: Caster Arm
25
A
E
C
F
D
B
A
Revision A
Advertisement
Table of Contents
