Table of Contents
Advertisement
• Firewall extension module (A)
Two connectors: P227 and P226
Location: Behind the cab, near the header lift/fan manifold
To disconnect a connector, press center red tab (B), to
release the latch, then lift the latch and pull the connector
away from the module.
IMPORTANT:
When reconnecting these connectors, make sure to latch
them in place.
IMPORTANT:
Do NOT power up or operate the windrower until these
connectors are latched into place.
• Engine Control Module (ECM)
Two connectors for Cummins: P100 (A) and J1 Cummins
Proprietary ECM Connector (B)
Location: On the engine
To disconnect the connectors, pull the rubber boot off of
the cover, unlock the latch, and undo the main over-center
latch. Remove strain relief bolts (C) so that the connectors
can be pulled away from the ECM.
IMPORTANT:
Be sure to disconnect both connectors. Note the connector
locations for reinstallation.
IMPORTANT:
Be sure to reconnect the connectors in the proper locations.
Do NOT cross connect the connectors.
• Cab connectors (A)
Two round connectors: C1 and C2
Location: Under the cab
NOTE:
To disconnect circular Deutsch connectors, rotate the outer
collar counterclockwise.
IMPORTANT:
To connect circular Deutsch connectors without bending the
pins, fully align the plug with the receptacle before pressing
the connector in.
262175
SAFETY
Figure 1.18: Firewall Extension Module
Figure 1.19: Engine Control Module
Figure 1.20: Cab Connectors
9
B
B
B
A
A
A
C
C
Revision A
Advertisement
Table of Contents
