Table of Contents
Advertisement
10. Attach rubber strap (D) to straight pin (C) at the rear of the
windrower leg. Secure it with washer (B) and lynch pin (A).
11. Repeat Step
9, page 160
opposite side of the forming shield.
5.4.2 Attaching R2 Series Rotary Disc Header
The windrower's support feet and center-link will need to be connected to the rotary disc header. The windrower may be
equipped with an optional self-aligning hydraulic center-link, which allows control over the vertical position of the center-
link from the cab.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Clear all bystanders from the area.
2. Shut down the engine, and remove the key from the ignition.
3. Remove hairpin (A) from clevis pin (B), and remove the pin
from header support (C) on both sides of the header.
262175
ATTACHING HEADERS TO WINDROWER
to Step
10, page 161
at the
Figure 5.144: Rubber Strap Securing Forming Shield
onto Windrower Leg
C
Figure 5.145: Header Support
161
C
B
D
B
A
A
Revision A
Advertisement
Table of Contents
