1. Clear all bystanders from the area.
2. Open the cab door, turn the IGNITION switch to the ON
position, and confirm that the HarvestTouch
up and shows the MacDon logo.
3. Start the engine. For instructions, refer to
Engine, page
58.
4. If a header is attached to the windrower, confirm that the
™
HarvestTouch
Display displays the header-disengaged
page (A).
NOTE:
The illustration shows a draper header attached to the
windrower. If an auger or rotary disc header is attached to
the windrower, the page will look similar.
5. If a header is not attached to the windrower, confirm that
™
the HarvestTouch
Display displays the no-header page (A).
262175
PERFORMING PREDELIVERY CHECKS
™
Display boots
4.1.10 Starting
Figure 4.29: HarvestTouch
Figure 4.30: HarvestTouch
Disengaged
Figure 4.31: HarvestTouch
72
Display – Boot-Up
™
A
Display – Header
™
A
Display – No Header
™
Revision A