Table of Contents
Advertisement
6. Remove and retain hairpin (D) and clevis pin (C) from
header support (B) and windrower lift linkage (A). Repeat
this step at the opposite side of the windrower.
7. Windrowers with self-aligning center-link: Release center-
link latch (A).
8. Disengage the safety props on both lift cylinders as follows:
a.
Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
9. Start the engine.
262175
ATTACHING HEADERS TO WINDROWER
133
B
Figure 5.78: Header Leg and Windrower Lift Linkage
Connected by Header Support
Figure 5.79: Center-Link
A
Figure 5.80: Safety Prop Lever
A
D
C
A
Revision A
Advertisement
Table of Contents
