6. Remove header leg pin (B) by removing hairpin (A) from
header leg on both sides of the header.
7. Lower header stand (D) by pulling spring loaded pin (C).
Release the spring pin to secure the lock stand.
8. Windrowers with self-aligning center-link: Release center-
link latch (A).
9. Disengage the safety props on both lift cylinders as follows:
a.
Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
10. Start the engine.
262175
ATTACHING HEADERS TO WINDROWER
153
A
C
B
Figure 5.124: Header Leg and Header Stand
Figure 5.125: Center-Link
A
Figure 5.126: Safety Prop Lever
D
A
Revision A