Table of Contents
Advertisement
1. Park the windrower on level ground.
2. Rotate the wheel drive until fill/drain plug (A) is at the
12 o'clock position and check plug (B) is at the 3 o'clock
position as shown.
3. Shut down the engine, and remove the key from
the ignition.
WARNING
Use caution when removing the plug, as the fluid may still be
under pressure.
4. Remove check plug (B). The lubricant should be visible
through the port. Some lubricant may leak from the port.
5. Reinstall check plug (B). Torque the plug to 7.5 Nm
(72 lbf·in).
6. If removed, reinstall fill/drain plug (A). Torque the plug to
24 Nm (216 lbf in).
4.1.13 Checking Tire Pressure
The windrower's drive and caster tires must be inflated to the proper pressure level.
Caster wheel tires: Inflate all caster wheel tires (B) to
110 kPa (16 psi).
Drive wheel tires: Drive wheel (A) tire pressures are determined
by tire type, header size, and by the options installed on the
windrower. Refer to the following tables to determine the
appropriate tire pressure for the windrower:
• D2 Series Draper Headers: Table
• D1X / D1XL Series Draper Headers: Table
• Rotary Disc Headers: Table
• Auger Headers: Table
4.5, page 69
262175
PERFORMING PREDELIVERY CHECKS
4.2, page 65
4.3, page 67
4.4, page 69
A
Figure 4.26: Wheel Drive – 12 Bolt
A
Figure 4.27: Windrower Tires
64
B
B
Revision A
Advertisement
Table of Contents
