Table of Contents
Advertisement
3. If the windrower was previously attached to an R216 Rotary
Disc Header, make sure to remove the forming shield (not
shown), including forming shield support brackets (A) and
hardware (B) from both legs. You can store the brackets
and hardware in the windrower tool box.
• For instructions on removing the R216 forming shield,
refer to
5.4.6 Removing Forming Shield from the
Windrower, page
197.
4. Before beginning this procedure, make sure draper header
supports (A) are installed on both windrower lift linkages.
For instructions on installing the header supports onto the
windrower, refer to
5.3.1 Attaching Draper Header
Supports, page
139.
5. Remove hairpin (A) from pin (B), and remove pin (B) from
the header leg. Repeat this step on the opposite header leg.
6. Start the engine.
262175
ATTACHING HEADERS TO WINDROWER
141
A
B
Figure 5.97: Forming Shield bracket – R2 Series
Figure 5.98: Header Supports Installed
A
B
Figure 5.99: Header Leg
A
Revision A
Advertisement
Table of Contents
