Table of Contents
Advertisement
3.7 Installing Windshield Access Step
The windshield access step will need to be installed onto the railing of the windrower's right cab-forward side platform.
1. Remove windshield access step (A) from the shipping
location on the right platform. Remove packing
materials (B) from the step and the railing.
2. Retrieve three M10 screws (A) (MD #136209) from the
toolbox.
3. Position step (A) on the right cab-forward leg at the
forward end of the platform as shown.
4. Install two M10 screws (B) (MD #136209) through the top
of the step. Do NOT tighten the hardware yet.
5. Install one M10 screw (C) (MD #136209) through the step
support.
6. Tighten the screws to 57 Nm (43 lbf·ft).
262175
ASSEMBLING WINDROWER
Figure 3.39: Step in Shipping Position
Figure 3.40: (MD #136209)
Figure 3.41: Windshield Access Step Installed
38
B
A
A
B
A
C
Revision A
Advertisement
Table of Contents
