Table of Contents
Advertisement
4. Remove banding and blocking (A) securing the walking
beam to the frame.
5. Approach the front of the windrower with a forklift. Slide
the forks under the frame.
IMPORTANT:
Ensure that the forks do NOT contact fuel tank (A). Ensure
that the forks lift ONLY the windrower's frame.
6. Raise the windrower approximately 152 cm (60 in.) off of
the ground. Place suitable stands under the drive wheel
legs and the rear frame. Lower the windrower onto the
stands so that the forklift's forks are partially unloaded.
7. Attach sling (B) to caster assembly (A).
8. Confirm two washers (C) are already placed on caster wheel
spindle (D).
9. If caster assembly (A) is on a pallet, remove the banding
and shipping material securing the assembly to the pallet.
262175
ASSEMBLING WINDROWER
Figure 3.9: Walking Beam Secured to Frame
Figure 3.10: Lifting Windrower
Figure 3.11: Caster Wheel Assembly in Shipping
Configuration
24
A
A
A
C
D
B
Revision A
Advertisement
Table of Contents
