Table of Contents
Advertisement
4. Before beginning this procedure, make sure both draper
header supports (A) are either:
• (B) Installed on the windrower lift linkages, or
• (C) Installed in the header legs
For instructions on installing the header supports onto the
windrower, refer to
5.2.1 Attaching Draper Header
Supports, page
118. Header supports are typically left
installed in the header legs when the header is detached
from the windrower.
5. Prepare the header as follows:
• If the header supports are installed on the windrower:
Remove ring (A) and pin (B) from the header leg.
• If the header supports are installed in the header:
Remove hairpin (C) and clevis pin (D) from the
header support.
Repeat this step on the other header leg.
6. Start the engine.
262175
ATTACHING HEADERS TO WINDROWER
120
A
B
C
A
Figure 5.52: Header Supports Installed
A
B
D
Figure 5.53: Header Leg — Left Side Shown
C
Revision A
Advertisement
Table of Contents
