MacDon M2170 Unloading And Assembly Instructions page 18

Windrower
Hide thumbs Also See for M2170:
Table of Contents

Advertisement

• Roof connectors (A)
Four connectors: C10, C12, C13, and C14
Location: Under the cab at the base of the left cab post
NOTE:
To disconnect circular Deutsch connectors, rotate the outer
collar counterclockwise.
IMPORTANT:
To connect circular Deutsch connectors without bending the
pins, fully align the plug with the receptacle before pressing
the connector in.
• Chassis relay module (A)
Three connectors: P240, P241, and P242
Location: Outside the left frame rail near the batteries
• Engine harness (A)
Two round connectors: C30 and C31
Location: Inside the left frame rail, at the rear of the
windrower
NOTE:
To disconnect circular Deutsch connectors, rotate the outer
collar counterclockwise.
IMPORTANT:
To connect circular Deutsch connectors without bending the
pins, fully align the plug with the receptacle before pressing
the connector in.
262175
SAFETY
Figure 1.21: Roof Connectors
A
Figure 1.22: Chassis Relay Module
A
Figure 1.23: Engine Harness
10
A
Revision A

Advertisement

Table of Contents
loading

This manual is also suitable for:

M2260

Table of Contents