Table of Contents
Advertisement
Parameter/
Explanation
Range
COSM BASS B
The signals are connected at the point where
the COSM BASS B is output.
The audio output from the computer, in-
stead of the COSM bass sounds played by
the connected bass, is input to the effects.
* POLY FX are not applied.
NORMAL PU
The signals are connected at the normal
pickup input.
The audio output from the computer, in-
stead of the normal sounds played by the
connected bass, is input to the effects.
MAIN OUT
The signals are connected at the point where
MAIN OUT is output.
The signals from the VB-99's MAIN OUT
and the audio output from the computer are
mixed and output.
SUB OUT
The signals are connected at the point where
SUB OUT is output.
The signals from the VB-99's SUB OUT and
the audio output from the computer are
mixed and output.
MAIN&SUB
The signals are connected at the point where
both MAIN OUT and SUB OUT are output.
Each of the signals from the VB-99's MAIN
OUT and the audio output from the com-
puter are mixed, SUB OUT and the audio
output from the computer are mixed from
the output.
IN LEVEL
0–200
Adjusts the volume level of the digital audio
received via USB (from the computer).
USB OUT
This sets the point internally within the VB-99 from which signals are
output via USB (to the computer).
COSM BASS A
The output from COSM BASS A is output.
COSM BASS B
The output from COSM BASS B is output.
NORMAL PU
The normal pickup input is output.
CH A
The output from Channel A is output.
CH B
The output from Channel B is output.
MIXER (DRY)
The signals that have been mixed with the
mixer, but before application of DELAY/
REVERB, are output.
MIXER
The signals that have been mixed with the
mixer and have DELAY/REVERB applied
are output.
MAIN OUT
The same signals as those from MAIN OUT
are output.
SUB OUT
The same signals as those from SUB OUT
are output.
OUT LEVEL
0–200
Adjusts the volume level of the digital audio
output via USB (to the computer).
Chapter 6 Using the VB-99 Connected to a Computer Via USB
Setting the Direct Monitor
1.
Press [SYSTEM].
2.
Press PAGE [
] [
3.
Press [F2] (USB).
4.
Press PAGE [
] to go to Page 2.
5.
Change the setting's value with [F2] (SELECT),
[F3] (OFF/ON) or the F2, F3 knobs.
For more information on signal paths set by the Direct
Monitor parameter settings, refer to "Signal Flow" (p.
15).
6.
Press [EXIT] one or more times to return to the
Play screen.
] to go to Page 2.
67
Advertisement
Table of Contents
