Delay (Add Echoes To The Sound); Switching Delay On/Off; Adjusts The Delay Volume For Each Part (Part Delay Level); Making Detailed Settings - Roland Groovebox MC-307 Reference Manual

Chapter 4 Setting Effects
Delay
(Add echoes to the sound)
Delay is an effect which adds echoes to the sound. It is
effective when applied to solo phrases or to densely
rhythmic phrases. Described here is how to set the Delay
effect.

Switching Delay On/Off

Procedure
1. Press the [SYSTEM] button.
The System Parameter Menu screen appears.
2. Press the [F1 (SYS)] button.
3. Press the [CURSOR (up)] button to access the screen for
items 1–4.
4. Press the [F1 (SND)] button.
The "SYSTEM: SOUND" screen appears.
5. Place the cursor at "DELAY SW".
6. Set ON/OFF using the [VALUE] dial or the [INC/DEC]
buttons.
Range: OFF, ON
There are a number of places where settings can be made that
affect the Delay level and related switches. If the effect does
not work with the above settings, check whether:
- The effect is not applied when the GRAB switch is
positioned at OFF if the MC-307 has been set to use
the GRAB switch. To always make the effect take
effect, put the GRAB switch at ON. (P. 62)
- After confirming that the value set for "DELAY:
DELAY LEVEL" is not too low, proceed with
making the setting. (P. 44)
- Confirm that the "DELAY Volume for Each Part"
in the next item is not set too low.
44
Adjusts the Delay Volume for
Each Part (Part Delay Level)
Procedure
1. Press the [PTN] button.
The screen for playing patterns appears.
2. Press the [F2 (STUP] button.
The Setup Menu screen appears.
3. Press the [F3 (PART)] button.
4. Use the [F1 (
)] and [F2 (
"PART MIXER: DLY LEVEL" screen.
5. Press the [PART SELECT] button, then press the part
button ([R], [1] to [7]) for the part you want to set.
* Instead, you can select the part with the [CURSOR (right/
left)] buttons.
6. Set a value using the [VALUE] dial or the [INC/DEC]
buttons.
Range: 0–127

Making Detailed Settings

Defines the settings for using Delay at a specific level.
Procedure
1. Press the [PTN] button.
The screen for playing patterns appears.
2. Press the [F2 (STUP] button.
The Setup Menu screen appears.
3. Press the [F3 (DLY)] button.
4. Use the [F3 (
)] and [F4 (
containing the following parameters you want to set.
5. Using the [CURSOR (up/down)] buttons, move the
cursor to the parameter you want to set.
)] buttons to select the
)] button to select the screen