Setting The Mix Balance; Setting The Delay And Reverb (Delay/Reverb); Using Playing Dynamics To Control The Mix Between The Two Channels (Dynamic) - Roland V-Bass VB-99 Owner's Manual

Chapter 2 Creating Sounds

Setting the Mix Balance

You can set the mix balance of Channel A and Channel B with the
BALANCE knob. Soon after the knob is turned, the balance value
pops up in the screen.
* You can also adjust this parameter in Page 2 of the Mixer screen.
* This knob is disabled when the Dynamic function is switched on.
Setting the Delay and Reverb
(DELAY/REVERB)
This sets the mixer section's delay and reverb.
1.
Press [DELAY/REVERB].
2.
Press PAGE [ ] to display Page 1.
3.
Switch the delay on or off with [F1] (OFF/ON);
switch the reverb on or off with [F4] (OFF/ON).
4.
Set the parameters with [F1]–[F6] or with the
F1–F6 knobs.
* Each press of PAGE [ ] takes you to the settings screen for the
next parameter.
5.
Adjust the parameters until you achieve the
desired sound.
6.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If not saving the values, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
"DELAY/REVERB" (p. 133).
32
Using Playing Dynamics to
Control the Mix Between the
Two Channels (DYNAMIC)
You can control the mix between the two channels according to how
strongly the strings are picked.
1.
Press [DYNAMIC].
2.
Press PAGE [ ] to display Page 1.
3.
Switch the Dynamic function on or off with
[F1] (OFF/ON).
4.
Select the Dynamic function type.
5.
Press PAGE [ ] to display Page 2.
6.
Set the parameters with the F1–F5 knobs.
7.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If not saving the values, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
"DYNAMIC" (p. 134).