Recording And Playing Back A Performance; Recording A Performance; Playing Back The Performance - Roland HS-5 Owner's Manual

Using the HS-5

Recording and Playing Back a Performance

The HS-5 can record your performance on a USB flash drive connected to the MEMORY port.
NOTE
The output of the main mixer is recorded.
The recording is not affected by the settings of each section's [PHONES] knob and [MY MIX] knob, nor
by the setting of the [MAIN MIX OUT] knob.

Recording a Performance

Here's how to record your performance onto a USB flash drive.
1
Connect your USB flash drive (sold separately) to the MEMORY port.
* You must first use your computer to format the USB flash drive (FAT format).
All data on the USB flash drive is erased when you format it. If the USB flash drive contains data that
you want to keep, make a backup before you proceed.
2
Press the button to start recording your performance.
3
When you finish your performance, press the
About the recorded data
The data is recorded in 16-bit 44.1 kHz stereo WAV format. A single
recording can contain up to 200 minutes.
The recorded data is stored on the USB flash drive in a folder named
"HS-5" with the file name HS5_****.wav (**** is the order in which the
recording is created).
8
Button Operation
Stops playback or recording.
Starts playback.
Starts recording
Rapidly press (tap) twice Selects the preceding data.
Selects the next data.
+
Rewind.
+ [MIX A]
Fast-forward.
+ [MIX D]
button to stop recording.
/Root
HS-5
HS5_0001.WAV
HS5_0002.WAV
HS5_0003.WAV

Playing Back the Performance

Here's how to play back a performance that you recorded on a USB flash drive, to listen to it or practice
along with it.
1
Connect your USB flash drive (sold separately) to the MEMORY connector.
2
Select the data that you want to play back, and press the
3
To stop playback, press the button.
5 If a click tone is sounding during playback, the click tone also stops.
5 By holding down the [CLICK/TAP] button and pressing the
tone.
Adjusting the recording level and playback level
* Normally there is no need to make these adjustments.
Adjusting the recording level
1 Check the recording level.
If the sound distorts during recording, the
Adjust the recording level.
2 Adjust the recording level.
Hold down the button and turn LEVEL knob [A] to adjust the level.
Adjusting the playback level
If the playback volume is too high, you can adjust the playback level as follows.
1 Adjust the playback level.
Hold down the button and turn LEVEL knob [A] to adjust the level.
button.
button you can stop just the click
button blinks.
Factory-set value