System Settings; Accessing The System Screen; Setting The Auto-Off Function - Roland M-200i V-mixer Owner's Manual

System settings

Accessing the SYSTEM screen

1.
In the top panel's DISPLAY section, press [SETUP].
2.
At the SETUP screen, select "SYSTEM" and press [ENTER].
The SYSTEM screen is displayed.
At the SYSTEM screen, you can make the following settings:
SAMPLING FREQ
1
This selects the sampling frequency at which the M-200i
operates. You can select either 48 kHz or 44.1 kHz.
CH-MUTE OPTION
2
You use this to set how a channel mute button behaves
when pressed.
Items displayed with "ON" are enabled. The selection items
are as follows:
Mutes AUX/MTX Turning this on makes the input-channel muting
SENDS also mute out sends to AUX and MTX.
Mutes DIRECT Turning this on makes the input-channel muting
OUTS also mute out DIRECT OUTs.
MAIN MUTE
3
This enable or disable the top panel [MUTE] for MAIN.
AUTO OFF
4
This button accesses the AUTO OFF screen for setting the
function to turn off the power automatically (p. 111).
DISPLAY/PANEL
5
This button accesses the DISPLAY/PANEL screen for setting
the brightness and contrast of the panel and display (p. 112).
DATE/TIME
6
This button accesses the DATE/TIME screen for setting the
date and time (p. 112).
DELAY UNIT
7
This selects the unit used for delay at the CHANNEL EDIT
screens (AUX, MTX, or MAIN) and the MONITOR screen.
The selection items are as follows:
ms Milliseconds
Feet Feet
Meter Meters
Frame Frames (24, 25, 29.97, or 30 fps)
Sample Sample

Setting the auto-off function

This sets the function for turning off the power automatically.
1.
Access the SYSTEM screen.
2.
Select "AUTO OFF" and press [ENTER].
The AUTO OFF screen is displayed.
Select one of the following as the AUTO OFF time:
OFF The auto-off function is disabled.
8HOURS The power is turned off automatically if 8 hours pass
without any controller being operated.
When the auto-off function has been turned on, a message
informing you that auto-off is on is displayed at startup (p. 15).
111