4-Band Eq; 4-Band Eq Operations - Roland M-200i V-mixer Owner's Manual

4-BAND EQ

4-band EQ operations

A 4-band EQ is provided on each CH1 through 32, MAIN L and R, AUX1 through 8, and MTX1 through 4 channel.
About 4-band EQ for CH1-32
The LO and HI bands provide shelving-type or peaking-type filters, and the LO-MID and HI-MID bands provide peaking-type filters.
Also, 12-dB/octave high-pass filters that pass the region higher than the specified frequency are provided for CH1 through 32.
About 4-band EQ for AUX1-8, MTX1-4, and MAIN L/R
The LO and HI bands provide the three types of shelving, peaking, and low-pass or high-pass type filters, and the LO-MID and HI-MID
bands provide peaking-type filters.
Operating the 4-band EQ
1.
In the fader module section, press [SEL] to select the
desired channel.
2.
In the CHANNEL EDIT section, press [EQ].
fig.PopEQGuide.eps
The EQ screen is displayed.
3.
Use the up and down cursor buttons to change the page
and change the band to manipulate.
1 IN meter
This indicates the input level of the 4-band EQ. For stereo-
linked channels, two meters (L and R) are shown.
2 4-band EQ graph
This indicates the approximate response of the 4-band EQ.
3 OUT meter
This indicates the output level of the 4-band EQ. For stereo-
linked channels, two meters (L and R) are shown.
4 GAIN
This adjusts the gain in a range of -15.0 dB to +15.0 dB.
FREQ
5
This adjusts the center frequency in a range of 20 Hz to 20.00
kHz.
Q
6
This adjusts the Q (of the peaking-type filters) in a range of
0.36 to 16.00. Higher values produce a sharper curve.
EQ button
7
This turns the 4-band EQ on/off.
HPF button (only when the HPF band is selected)
This turns the HPF on/off.
This is displayed only when a channel from CH1 to 32 is
selected.
Noise may occur when you operate the filter or 4-band EQ,
but this is not a malfunction.
For some filter types, GAIN or Q is not displayed.
55