Table of Contents
Advertisement
4-2 Peripheral devices
Personal computer workstations
553-4011-110 Standard 1.0 November 1994
PCs supported by the NAC 2 system are the IBM PS/2 30 and the Compaq
Deskpro with:
AT-style or enhanced-style keyboard
512 Kbytes of RAM
Paradise EGA or VGA card with 256 Kbytes of memory
either one 5.25 inch floppy disk drive, two floppy disk drives, or one
floppy disk drive and hard disk (3.5 in. or 5.25 in. disk drives can be
used)
Reflection 4+ software
The VDTs supported by the NAC are the DEC VT220, DEC VT420 (North
American and Worldwide models) and 100% compatibles.
Unpack and assemble the PC workstation by following the installation
instructions given in the manufacturer's user manual. Perform all setup
and/or diagnostic routines to ensure the viability of the equipment. This
includes formatting the hard disk (if present) as the DOS start-up drive.
Install the Reflection 4+ software to the hard disk (if present).
Connect the workstation to the NT8D96AE cable on the application
module. Refer to the "Cables" section of the "Hardware installation"
chapter for more information on these cables.
To configure your PC workstation for use with Reflection 4+, refer to the
"Workstation configuration" section.
Before you start or restart the NAC, and each time you power up the PC,
you must follow the appropriate instructions on the next page.
Advertisement
Table of Contents
