Northern Telecom NAC Installation Manual page 359

Procedure 10-3 (continued)
Switching from Precutover mode to Product mode for NAC 2 systems
Step Installer's action and system's response
mount –f S51K /dev/usr /usr
Checking for system dump...
Expreserve notification performed.
Downloading MVME332XT Line Discipline.
Error logging started.
OSM logging started.
port_hold started
Stream Error logging started.
netspec "tcpip" not set up.
Line printer scheduler started.
7 The system displays the following prompts.
The current Date and Time are 'Mon Feb 14 12:42:00 STD 1994'
Do you wish to change the current Date and Time (y/n) ?
If you don't wish to change the current date and time, enter n, followed by {RE-
TURN}. Go to Step 8.
If you wish to change the current date and time, enter y, followed by {RETURN}.
The system asks you to enter the correct date and time, where the first pair of num-
bers represent the month, the second pair of numbers represent the day, the third
pair represent the hour in the 24-hour time cycle, the fourth pair of numbers repre-
sent the minutes, and the last pair of numbers represent the last two digits of the
year. For example, if 0211152594 was entered, the system would ask you the follow-
ing question.
Are the new Date and Time 'Fri Feb 11 15:25:00 STD 1994', correct (y/n) ?
If the date and/or time you entered is incorrect, enter n, followed by {RETURN}. The
system then returns you to Step 20. If the date and time you entered are correct,
enter y, followed by {RETURN}. The system continues.
Network Administration Center (NAC) Installation Guide Product release 2
Enter new Date and Time [mmddhhmmyy] :
—continued—
Operating modes 10-31